Networked measuring system
During the measurement, the results can be viewed and evaluated in detail on the networked computer in parallel
Vehicle measurement with current clamp
The extra large diameter of the clamp allows measurements on thick cable bundles
Measurements
- Measurement of the emission in cars and commercial vehicles
- Suppression measures on the HV network, on CAN and signal cables
- Interference elimination of test stands
RF current clamps are ideally suited for rapid checking of the disturbance conditions in electric vehicles and test benches for electric drive systems
However, the correct interpretation of the measured interference currents requires a great deal of experience and comprehensive understanding of the propagation and coupling of the RF currents
Often, the location of the maximum measured noise level is not at all the source of the interference itself
The demands placed on a measuring system in such an environment differ significantly from the usual normative applications:
What is needed is a high level of flexibility - fast setting of all measurement parameters - without the know-all patronizing of the measuring program - and, of course, short measurement times
Further accelerations result from an automatic, continuous storage of the measurements - and from a parallel processing and evaluation on the LAN-connected Co-PC
Complete Measurement 10 kHz - 30 MHz
Zoomed Range 5 - 10 MHz
The measured data are always available as the complete measured values of the receiver or analyzer - including all comments
Each individual measurement can therefore be evaluated without any problem even at a later time in detail and displayed as desired
© Ingenieurbüro Lindenberger 8447